Introduce D-Ring Tie Down Anchor

  • D-Ring
  • Tie-Down Cleats and Rings
  • Recessed Mount
  • Trailer Tie-Down Anchors
  • 2000 lbs

This steel D-ring creates an attachment point for tie-down straps and bungee cords wherever you need cargo control. The recessed design allows you to roll cargo over the ring. Zinc plating provides corrosion resistance.


  • Maximum load (break strength): 6,000 lbs
  • Safe working load limit (WLL): 2,000 lbs
  • Anchor:
  • Bezel dimensions: 4-1/2″ wide x 4-7/8″ tall
  • D-ring thickness: 1/2″
  • Inner ring diameter: 1-3/8″
  • Recess dimensions: 3-3/8″ wide x 3/4″ deep
  • Bolt hole dimensions: 3/8″ wide x 3/8″ long


  • Tie-down provides a solid point to secure your cargo with straps or bungee cords
  • D-ring pivots 90 degrees so you can attach straps from multiple angles
  • Recessed design allows cargo to slide over the ring without interference
  • Zinc-plated steel construction resists corrosion and retains its strength through repeated use
  • 1/4″ Hole located underneath D-ring for drainage
  • Simple, bolt-on installation
  • Square mounting holes
  • Mounting hardware not included

Introduce D-Ring Tie Down Anchor

Note: Tie-down anchors must be chosen according to their safe working load limit (WLL). The weight of the secured cargo must not exceed the combined WLL of the anchors being used. For example, if you are using anchors with a WLL of 100 lbs each to tie down a load weighing 400 lbs, then you need at least 4 anchors to safely secure that load. It is recommended that you always use anchors in pairs.

Post time: Jan-06-2022